LZ-NH500N Bracket
Typical mounting on IN-SWINGING door
L-Bracket
Armature
Frame
Z-Bracket
Door
In-Swinging
48
267
Application for the Electromagnet:
EM-NH500 Series
75
63.5
6
190
63.5
63.5
190
8
63.5
Unit:mm
Installation Steps of LZ bracket for In-swinging doors
1
2
3
4
Slide the electromagnetic lock to fit
with the mounting plate and tighten
the electromagnetic lock on the L
bracket.
Find a mounting location on the
door frame for the L bracket. Make
sure that the door is still closeable.
Assemble the Z bracket, and make
sure that the Z bracket is adjustable.
Insert the guide pins into the
armature plate.
5
6
7
Finish
Power
Once the position is correct,
Put one rubber washer between
armature plate and the Z bracket.
Turn on the power of EM-Lock,
and let the armature plate bonds
to the EM-lock. Adjust the position
between the Z bracket and the
door frame.
Close the door. Measure the correct
position by bringing the armature
plate close to the contact surface of
the electromagnetic lock.
use the screws to permanently
mount the Z bracket on the door
frame. This should be the last step.
GIANNI INDUSTRIES, INC.
No. 13, Zhong Sing Road, Tu-Cheng Industrial Zone,
Tu-Cheng City, Taipei, Taiwan 23678
The products are manufactured under an ISO
9001 QC 080000 Certified Quality
&
Management Program environment back its
product quality, performance and commitment
to customer satisfaction.
Tel: 886-2 2267 7986 / Fax: 886-2 2267 9876
E-Mail: [email protected]
Website: gianni.tw
Copyright 2008 Gianni industries, inc. All rights reserved.
DM-CA-LZ-NH500N Ver. A Published on 2008.06.18
|