COMRADE™
WALL-HUNG LAVATORY
VITREOUS CHINA
BARRIER FREE
COMRADE™ WALL-HUNG LAVATORY
• Wall-hung sink
• Vitreous china
• Rear overflow
• Soap depression
• Faucet ledge (faucet not included)
❏ 0124.024 With wall hanger (Illustrated)
Faucet holes on 102mm (4") centers
❏ 0124.131 For concealed arms support
Faucet holes on 102mm (4") centers
Nominal Dimensions:
508 x 464mm
(20" x 18-1/4")
Bowl sizes:
381mm (15") wide
276mm (10-7/8") front to back
159mm (6-1/4") deep
102mm
(4)
64mm
(2-1/2)
171mm
(6-3/4)
FINISHED
WALL
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• ASME A112.19.2 for Vitreous China Fixtures
464mm
(18-1/4)
C/L
508mm
(20)
8mm x 27mm
(5/16 x 1-1/16) SLOTS
To Be Specified:
❏ Color: ❏ White ❏ Bone ❏ Silver
❏ Faucet*:
❏ Faucet Finish:
54mm (2-1/8) DIA.
HOLES FOR
CONCEALED ARMS
38mm
419 mm
(16-1/2)
267mm
(10-1/2)
S-9 HANGER
(1-1/2)
❏ Supplies:
❏ 1-1/4" Trap:
64mm
(2-1/2)
76mm
(3)
❏ Nipple:
203mm
(8)
108mm
(4-1/4)
❏ Concealed Arms Support (by others):
286mm
*
(11-1/4)
235mm
*
(9-1/4)
11mm (7/16) DIA.
ANCHOR SCREW
HOLES
* See faucet section for additional models available
*
349mm
203mm
(8)
(13-3/4)
SUPPLIES
AS REQ'D.
787mm (31)
864mm (34)
MEETS THE AMERICANS WITH DISABILITIES ACT GUIDE-
LINES AND ANSI A117.1 ACCESSIBLE AND USABLE
BUILDINGS AND FACILITIES - CHECK LOCAL CODES.
Top of front rim mounted 864mm (34") from finished floor.
DRAIN PLUG WASTE
OUTLET 1-1/4 O.D.
FINISHED
FLOOR
POP-UP WASTE
OUTLET 1-1/4 O.D.
NOTES:
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P” TRAP
*
ARE SUGGESTED.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
IMPORTANT: Dimensions of fixtures are nominal and may vary within
the range of tolerances established by ANSI Standard A112.19.2. These
measurements are subject to change or cancellation. No responsibility is
assumed for use of superseded or voided pages.
M26
© 2008 AS America Inc.
Revised 8/05
|